Conveyors with perma Gas Lubricators

Conveyor bearing lubrication presents a challenge for a range of reasons:

• Lubrication conditions are normally agressive due to high levels of contamination and bearing loads are often high.  This combination demands regular, short greasing intervals;
• Centralised lubrication systems are generally not economical due to the large distances between lubrication points;
• For manual lubrication the lube technician is presented with long walking distances, ladders and stairs.

Example 1:  Classic lubricator remote mounted using 0.75meters of grease line and an MB01SBC30 bracket.  The complete installation kit (excluding lubricator) is available as K130S0.75

Example 2:  Futura lubricator remote mounted using 1 meter long grease lines and a CH02 bracket.  The complete installation kit (excluding lubricator) is available as K2CHG.

Figure Example 4:  Futura lubricators direct installed on a conveyor pulley bearing in extreme contamination conditions

Example 5:  Futura lubricator direct mounted to a dead shaft bearing.  The lubricator is supported by an A620P support flange and rotates with the pulley.

Example 6: Direct mount Classic lubricators on feeder pulley bearings

Example 7: perma Futura on conveyors in the quarrying industry

Example 8: perma Classic remote mounted using a compact cage hanger bracket (part number for bracket is CH01S) 

^ Top of page | Open printer friendly page