139 results

Reducers and other fittings

Adaptor 1/4 BSP female to 1/8 BSP male 316SS Material: Stainless steel  Part No: 2461/8SS  Nipple hex 1/4 BSP male to 1/4 BSP male Material: Brass Part No: 280 1/4 BSP female round socket…

Extensions

Extension 40mm 1/4 BSP female to 1/4 BSP male brass Material: Brass Part No: 52740  Extension 85mm 1/4 BSP female to 1/4 BSP male brass Material: Brass Part No: 52785  Extension 125mm 1/4…

Elbows

90 deg elbow 9/16 JIC male to 1/4 BSPT male 316SS Material: Stainless Steel Part No: 92JSS 45 deg elbow 1/4 BSP female to 1/8 BSP male brass Material: Brass Part No: 1211/8 45 deg elbow 1/4 BSP…

Lubricants

Grease Grease Oil Additives Additives are organic or inorganic compounds mixed into the base oil to enhance the existing oil properties or to impart new properties. Examples: AW (anti-wear) and EP…

Applications

For years, perma-tec has been offering lubrication solutions uniquely suited for belt conveyors, electric motors, pumps, fans and blowers. This chapter explains the lubrication challenges and shows…

Conveyors

Lubrication points Pillow block housings and spherical roller bearings are used for drive / guide pulley support. Bearings and bearing housing seals must be permanently supplied with…

Electric motors

Lubrication points Lubrication points are located on the drive and non-drive end of the motor. Grease escape (grease drain hole, grease trap, grease relief port) is important. Bearings will overheat…

Pumps

Lubrication points Lubrication points (roller bearings) are located on the drive shaft between drive motor and pump. Lubrication of gland and labyrinth seals prevents the ingress of dirt or pumped…

Fans

Lubrication points The lubrication points (roller bearings) are located at the drive shaft between drive motor and fan impeller. Bearings and shaft seals must be permanently supplied with the right…

Gypsum, lime & cement plants

There are hundreds of rotating machine elements in gypsum, lime and cement plants. Equipment must function reliably under the most difficult operating conditions. Up to 80 % of machine failures are…